estiramientotvtv

Hey tankers!
Today we go over a simple turret rotation assembly swap. The swap is pretty straight forward:
- Remove the 3 screws that hold the unit in place.
- Cut or desolder the wires from the upper hull board.
- Splice or solder the wires back into place with the new unit.
- Secure unit back in place with the three screw holes.

Unfortunately(kinda?) my unit is not broke so I cannot demonstrate how to test it at the same time. We did however make another video in this playlist on how to diagnose DC brushed motors if you need to learn. Now the swap is simple, remove screws, replace unit, and either splice or solder the wires.

I personally will solder, but I understand some do not like to solder or do not want to. You can splice the wires just like it was a speaker wire, just make sure to tape them good afterwards so they do not contact each other or anything else.

Hey tankers,
Here is a quick unboxing of the Taigen Tanks KV-1. It features:
metal chassis (torsion bar suspension)
metal suspension arms
metal road wheels
metal return rollers
metal drive wheels
metal idler wheels
metal caterpillar tracks
metal toolboxes
metal 3: 1 gearboxes

The tank is RTR and comes with a 2.4GHz radio. A smoke unit, speaker, and recoil are extra included features for the tank. It also comes with either an airsoft or infrared firing unit. More information can be found at www.TaigenTanks.com

Hello tankers,
Here is a quick unboxing of the Torro KV-2. It features:
metal chassis (torsion bar suspension)
metal suspension arms
metal road wheels
metal return rollers
metal drive wheels
metal idler wheels
metal caterpillar tracks
metal toolboxes
steel 3:1 gearboxes

The tank is RTR and comes with a 2.4GHz radio. A smoke unit, speaker, and recoil are extra included features for the tank. It also comes with either an airsoft or infrared firing unit. More information can be found at www.TaigenTanks.com

Hello tankers!
Today we have a very special tank to show off... The Sherman! This is the M4A3 75mm turret version. This tank is a huge step up from our previous tanks, this guy has a solid 1 piece lower chassis, with NO structural plastic support on the inside of the tank except for the battery compartment and the on/off switch panel. This tank has 2mm thick fenders, back plate, and lower chassis! The suspension is metal as well as the road wheels, drive wheels, and idler wheels. The road wheels also have rubber tires :)
The turret is metal with a cast texture and has a metal barrel as well. It is our newest 360 degree turret design as well. The Sherman will become available in either airsoft or infrared versions.
The Sherman also comes with High/Low motor mounted gearboxes with a 3:1 ratio gearbox. A 4:1 will be made available for purchase at the same time for those who wish for a bit more torque. The stock gearboxes are steel and the motors are our new black can motors which should stay a bit cooler than our previous ones.
The Sherman also comes with a dedicated battery compartment as you will see in the video. It holds a standard 6 cell NIMH battery just fine and even held my 2 cell lipo (your mileage may vary there) perfectly. This is a nice addition as we now do not have to worry as much about if our batteries are flopping around in the tank as much.
This tank will be made available in October hopefully in time for the movie Fury!