estiramientotvtv

Hey tankers!
Today we go over a simple turret rotation assembly swap. The swap is pretty straight forward:
- Remove the 3 screws that hold the unit in place.
- Cut or desolder the wires from the upper hull board.
- Splice or solder the wires back into place with the new unit.
- Secure unit back in place with the three screw holes.

Unfortunately(kinda?) my unit is not broke so I cannot demonstrate how to test it at the same time. We did however make another video in this playlist on how to diagnose DC brushed motors if you need to learn. Now the swap is simple, remove screws, replace unit, and either splice or solder the wires.

I personally will solder, but I understand some do not like to solder or do not want to. You can splice the wires just like it was a speaker wire, just make sure to tape them good afterwards so they do not contact each other or anything else.

Hello tankers,
Today I will show you how to bind our tanks in a bit more detail than the previous video. Remember these steps:
1. Left toggle away from you, right toggle towards you on transmitter.
2. Turn on tank and transmitter at same time. Transmitter light will blink.
3. When transmitter light goes solid press the right toggle switch forward.

Enjoy! You are now bound to your tank! If you use the left toggle switch (ignition switch) you can start you tank and start tanking away.